THIS AUCTION IS FOR 6 PC UPDATE STEPPER
MOTOR, PART # X 27 168, free 11 Blue LED Backlights
Comes with 11 PC High
Quality, Blue LED cluster bulbs, Built-in Current Limiting Resistor, No need to
add a external resistor. 6-gauge clusters take 8 bulbs, 7-gauge clusters take 9
bulbs, 11 bulbs will be enough to replace all of the backlight bulbs in most, if
not all GM clusters 2000-2007.
These stepper motors are a direct
replacement for the XC5.168 and X15.168 faulty steppers commonly found in 2001
thru 2006 General Motors instrument clusters.
If your Speedometer
is experiencing any of the problems listed below, then these NEW UPDATED stepper
motor will fix your problem.
- any gauge dead.
- stickey gauges.
- gauges not reading correctly.
- Needles peg out, and come back after it sets
and then it only goes down 5 miles at a time when you turn the key on.
- And any other weird thing.
These Are Updated
Generation 5 Version Stepper motors X27.168
THAT GO BAD IN THE TRUCKS AND CARS LISTED BELOW, GM GMC cars and trucks FROM
2003 TO 2006
Each Gauge has a stepper motor and the
stepper motor is the same for all gauges.
6 x new x27.168 stepper motors. (Genuine
Juken-Switec/OEM, the latest/greatest 5th gen) To repair up to 6 malfunctioning
soldering iron. 60W
solder sucker (desolder pump). Desoldering wick/braid isn't
recommended with sensitive PCB
soldering wire （about 1ft）. 1 ft 2.0% flux rosin core
Unleaded solder (Green)
Needle removal tool(instead of fork to avoid break the
gauge cluster and those delicate needles as you take it apart)
6 pieces of tape(Mark the locations of the dials)
Fit the following vehicles:
2003 , 2004, 2005, 2006
Chevy CAVALIER (2000, 2001, 2002 - 2006)
Pontiac GRAND AM
Pontiac GRAND PRIX (not 2006)
Chevy IMPALA ((2000, 2001, 2002 - 2005, not 2006)
Chevy MONTE CARLO (not 2006)
Pontiac SUNFIRE (2000, 2001, 2002 - 2006)
Chevrolet TRAILBLAZER (2002-2006)
WARNING ! PLEASE
READ THE FOLLOWING BEFORE PURCHASING
Installing these motors requires
good soldering skills, professional equipment and electronic knowledge working
with delicate PC boards. the buyer are responsible for
installation charges and any damages incurred from the installation of the
6 Units x27.168 STEPPER MOTORS
11 Units Blue LED Backlights
1 x Soldering Iron
1 x Solder Sucker
1 x Solder Wire (About 1ft)
1 x Needle removal tool(instead of fork to avoid break the gauge cluster)
1 x Instructions
6 x tapes(Mark the locations of the dials)